跳到主要导航 跳到搜索 跳到主要内容

Achieving high adhesion and ablation resistance performance of plasma sprayed TiO2 coatings through the design of a sputtered TiO2 interlayer

  • J. Y. Zhu
  • , Y. Wang
  • , J. Wang
  • , T. B. Zhang
  • , Z. H. Wang
  • , Y. Bai
  • , X. N. Luo
  • , H. Jia
  • , J. Ma
  • , D. Hu
  • , J. Chen
  • State Key Laboratory for Mechanical Behavior of Materials
  • Xi'an Jiaotong University
  • Wuzhong Instrument Co., Ltd

科研成果: 期刊稿件 › 文章 › 同行评审

摘要

Plasma spraying of ceramics onto resin matrix composites is constrained by the thermal vulnerability of resin substrates and poor ceramic/resin interfacial compatibility. To overcome these issues, an ultrathin sputtered TiO2 interlayer was introduced on glass fiber-reinforced epoxy composites. The interlayer transforms the resin surface into a ceramic-compatible transition interface and promotes the formation of a crystallized TiO2/Ti6O11 intermixed zone at the sputtered/sprayed boundary. This transition structure mitigates the mismatch between the low-temperature sputtered film and rapidly quenched ceramic splats, yielding a TiO2 topcoat with a high coating/substrate bonding strength of 45.13 ± 0.89 MPa, exceeding most reported ceramic coatings on polymer-based composites. During repeated plasma ablation, the coating maintains a relatively low mass ablation rate, reaching 1.33 mg s−1 after 250 cycles, with damage evolving through ceramic-layer microcracking, defect coalescence and spallation. This sputtered-interlayer approach provides a route for integrating ceramic coatings onto polymer-based composites for thermal protection.

源语言英语
期刊Ceramics International
DOI
出版状态已接受/待刊 - 2026

学术指纹

探究 'Achieving high adhesion and ablation resistance performance of plasma sprayed TiO2 coatings through the design of a sputtered TiO2 interlayer' 的科研主题。它们共同构成独一无二的学术指纹。

引用此