Experimental and numerical study of developing turbulent flow and heat transfer in convergent/divergent square ducts

The work reported in this paper is a systematic experimental and numerical study of friction and heat transfer characteristics of divergent/convergent square ducts with an inclination angle of 1° in the two direction at cross section. The ratio of duct length to average hydraulic diameter is 10. For the comparison purpose, measurement and simulation are also conducted for a square duct with constant cross section area, which equals to the average cross section area of the convergent/divergent duct. In the numerical simulation the flow is modeled as being three-dimensional and fully elliptic by using the body-fitted finite volume method and the k-ε turbulence model. The uniform heat flux boundary condition is specified to simulate the electrical heating used in the experiments. The heat transfer performance of the divergent/convergent ducts is compared with the duct with uniform cross section under three constraints (identical mass flow rate, pumping power and pressure drop). The agreement of the experimental and numerical results is quite good except at the duct inlet. Results show that for the three ducts studied there is a weak secondary flow at the cross section, and the circumference distribution of the local heat transfer coefficient is not uniform, with an appreciable reduction in the four corner regions. In addition, the acceleration/deceleration caused by the cross section variation has a profound effect on the turbulent heat transfer: compared with the duct of constant cross section area, the divergent duct generally shows enhanced heat transfer behavior, while the convergent duct has an appreciable reduction in heat transfer performance.