Skip to main navigation Skip to search Skip to main content

Achieving high adhesion and ablation resistance performance of plasma sprayed TiO2 coatings through the design of a sputtered TiO2 interlayer

  • J. Y. Zhu
  • , Y. Wang
  • , J. Wang
  • , T. B. Zhang
  • , Z. H. Wang
  • , Y. Bai
  • , X. N. Luo
  • , H. Jia
  • , J. Ma
  • , D. Hu
  • , J. Chen
  • State Key Laboratory for Mechanical Behavior of Materials
  • Xi'an Jiaotong University
  • Wuzhong Instrument Co., Ltd

Research output: Contribution to journal › Article › peer-review

Abstract

Plasma spraying of ceramics onto resin matrix composites is constrained by the thermal vulnerability of resin substrates and poor ceramic/resin interfacial compatibility. To overcome these issues, an ultrathin sputtered TiO2 interlayer was introduced on glass fiber-reinforced epoxy composites. The interlayer transforms the resin surface into a ceramic-compatible transition interface and promotes the formation of a crystallized TiO2/Ti6O11 intermixed zone at the sputtered/sprayed boundary. This transition structure mitigates the mismatch between the low-temperature sputtered film and rapidly quenched ceramic splats, yielding a TiO2 topcoat with a high coating/substrate bonding strength of 45.13 ± 0.89 MPa, exceeding most reported ceramic coatings on polymer-based composites. During repeated plasma ablation, the coating maintains a relatively low mass ablation rate, reaching 1.33 mg s−1 after 250 cycles, with damage evolving through ceramic-layer microcracking, defect coalescence and spallation. This sputtered-interlayer approach provides a route for integrating ceramic coatings onto polymer-based composites for thermal protection.

Original languageEnglish
JournalCeramics International
DOIs
StateAccepted/In press - 2026

Keywords

  • Ablation
  • Composites
  • Plasma spraying
  • Sputtering
  • TiO

Fingerprint

Dive into the research topics of 'Achieving high adhesion and ablation resistance performance of plasma sprayed TiO2 coatings through the design of a sputtered TiO2 interlayer'. Together they form a unique fingerprint.

Cite this